Installation Instructions
How to install the Envoy on-hold message player:
1. Plug in the 5V DC power adapted into a wall outlet or power strip, connect the other end of the cable to the player's "power" barrel input (located on back of player).
2. Insert flash drive into the USB input, located on the front of the device.
*Use the "Speaker On/Off" button to preview the audio playing through the device*
3. Connect one end of the provided RCA audio cable to the player's 600 OHM output (located on back of player).
4. Connect the opposing end of the RCA audio cable to your phone system's corresponding MOH input (use provided 3.5mm adapter if needed).
5. Call into the phone system, place on-hold, and adjust volume level using the player's "UP" and "DN" buttons (located on back of player).
(Recommended that the Envoy's speaker button (on front of player) remains in the "Off" position after previewing.)